1·Weld joints to withstand 88 LBS pull force.
焊接头可以承受88磅拉力。
2·The top-head has large torque, wide range of speed, big pull force.
动力方扭矩大、转速范围广，起拔力大。
3·After the cycle test, the door shall meet the pull force requirements of section25.
循环试验结束后，后斜门应满足第25部分的拉力要求。
4·The door may be supported in a horizontal plane during the pull force measurement test.
在拉力测量期间，可以在水平面内对门进行支承。
5·Each insert withstands over 1,500 pounds (6672 n) of pull force when properly installed.
在正确安装后，每个嵌入件都能够承受1,500磅(6672 N)的拉力。
6·Threaded brass inserts shall withstand a direct pull force exceeding 1,500 lbs per insert.
每个螺纹黄铜嵌入件应该经受超过1，500磅的直接拉力。
7·Through-bolted fasteners shall withstand direct pull force exceeding 1,500 lbs. per fastener.
每个贯穿螺栓固定件应该能够承受超过1,500磅以上的直接拉力。
8·Through-bolted fasteners shall withstand a direct pull force exceeding 1,500 lbs. per fastener.
每个贯穿螺栓固定件应该能够承受超过1,500磅以上的直接拉力。
9·The study shows that the magnetic pull force can decrease both the first critical speed and the critical amplitude.
研究表明，磁拉力可降低一阶临界转速和临界振幅；
10·Interior shoe upper comer napping process for the joints of all kinds of shoe's upper And medium sole. to enhance the strength of glue pull force.
本机适用于各种皮鞋鞋帮与中底连接处的内邦角拉毛整理，以增加刷胶拉力强度。